Air Suspension System, Filling And Bleeding
Bleeding
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-Capable Systems
- 0074 - Suspension control J775
- 0074 - Suspension control functions
- 0074 - Basic setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
Filling
-- To fill proceed in the same way under
- Diagnostic-Capable Systems
- 0074 - Suspension control J775
- 0074 - Suspension control functions
- 0074 - Basic setting
CAUTION:
Risk of destroying the rear air springs due to incorrect handling when filling.
- Guide empty or newly installed air springs on the rear axle during the filling procedure.
-- Procedure when filling the air suspension system. Refer to Fig 1.