Overview - Charge Air System, Engine-Side, AUDI RSQ8 / Sq8 / Sq7

Fig 1: Exploded View Of Charge Air System, Engine-Side, Audi RSQ8 / SQ8 / SQ7

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • Quantity: 3
   • 7 Nm
2. Right Lower Air Duct Pipe on Throttle Valve Control Module:
   • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
3. O-Ring
   • Replace after removing
4. Throttle Valve Control Module -GX3- Cylinder Bank 1 (right)
   • Overview. Refer to OVERVIEW - INTAKE MANIFOLD .
   • Removing and Installing. Refer to THROTTLE VALVE CONTROL MODULE, REMOVING AND INSTALLING .
5. Bolt
   • Quantity: 2
   • 9 Nm
6. Right lower air duct pipe on the turbocharger
   • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
7. O-Ring
   • Replace after removing
8. Air Duct Hose
9. Right Upper Air Duct Pipe
   • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
10. Bolt
    • Quantity: 3
    • 9 Nm
11. Seal
    • Replace after removing
12. Turbocharger
    • Cylinder Bank 1 (Right)
    • Overview. Refer to OVERVIEW - TURBOCHARGER .
13. Turbocharger
    • Cylinder Bank 2 (Left):
    • Overview. Refer to OVERVIEW - TURBOCHARGER .
14. Seal
    • Replace after removing
15. Bolt
    • Quantity: 3
    • 9 Nm
16. Left Upper Air Duct Pipe
    • There are different versions. Refer to the Parts Information.
    • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
    • Disconnect and connect the crankcase ventilation hose. Refer to Fig 2.
17. Air Duct Hose
18. O-Ring
    • Replace after removing
19. Right lower air duct pipe on the turbocharger
    • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
20. Bolt
    • Quantity: 2
    • 9 Nm
21. Throttle Valve Control Module 2 -GX4- Cylinder Bank 2 (left)
    • Overview. Refer to OVERVIEW - INTAKE MANIFOLD .
    • Removing and Installing. Refer to THROTTLE VALVE CONTROL MODULE, REMOVING AND INSTALLING .
22. O-Ring
    • Replace after removing
23. Bolt
    • thread cutting
    • Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
    • 3.5 Nm
24. Bracket
    • For the air duct pipe
25. Left Lower Air Duct Pipe on Throttle Valve Control Module
    • Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
26. Bolt
    • Quantity: 3
    • 7 Nm
27. Air Duct Hose
28. Bolt
    • Quantity: 2
    • 6 Nm
29. Bracket
    • For 48 V: Wire to the starter generator

Crankcase Ventilation Hose on the Upper Air Duct Pipe, Rest of World Market Versions Excluding Engine Codes DWNB/DWRB

Fig 2: Crankcase Ventilation Hose on the Upper Air Duct Pipe

Courtesy of AUDI OF AMERICA, LLC

The crankcase ventilation hose -2- cannot be removed from the air duct pipe -1- without damage (example image).

• Replace the crankcase ventilation hose after removal.

-- Pry out the crankcase ventilation hose carefully using a screwdriver at the same time do not damage the air duct pipe.

-- Attach the new crankcase ventilation hose until it audibly locks on the air duct pipe.

Crankcase Ventilation Hose on the Upper Air Duct Pipe, North American Versions Excluding Engine Codes DWNB/DWRB

Fig 3: Crankcase Ventilation Hose on the Upper Air Duct Pipe

Courtesy of AUDI OF AMERICA, LLC

-- Do not disconnect the hose -2- for the crankcase ventilation (example image).

• The crankcase ventilation hose is not available separately.
• The crankcase ventilation hose is available in the air duct pipe delivery package -1-.