All Wheel Drive Clutch, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- Tightening specifications. Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH
- Check the O-ring -1- on the all-wheel drive clutch input shaft -2- for damage and if necessary replace.
- Apply a thin layer of Sealing Grease -G 052 128 A1- on the splines of the all-wheel drive clutch input shaft.
- Place the all-wheel drive clutch -1- on the transmission and tighten the bolts -arrows- hand-tight.
- Tighten the bolts -arrows- diagonally to the tightening specification.
- Connect the connector -3- to the All-Wheel Drive Control Module -4-.
- Secure the cable to the all-wheel drive clutch -arrow-.
- If equipped, secure the heat shield -2- with the bolts -1-.
- Lift the transmission slightly using the Engine and Gearbox Jack -VAS 6931 -.
- Tighten the tunnel crossmember bolts -arrows-. Tightening Specification. Refer to the appropriate Service Information.
- Check the ATF fluid level of the all-wheel drive clutch. Refer to OIL LEVEL, CHECKING .
- Install the drive shaft. Refer to the appropriate Service Information.
- If equipped, install driveshaft heat shield -1-.
- Install the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
If the clutch was replaced:
- If the all-wheel drive clutch was replaced, it must be activated under. Refer to ADDITIONAL WORK WHEN REPLACING ALL-WHEEL DRIVE CLUTCH .