Check the Clutch Installation Height
- Before installing the clutch the dimension -x- must be determined.
- To do so use the Ruler (2 pc.): T40100 and Digital Depth Gauge: VAS6087 to determine the height of the clutch cover to the hub offset as shown.
The dimension -x- must be within the tolerance of 98.91 to 99.61 mm.
- If the dimension -x- is outside of the tolerance, the clutch must be replaced because it is damaged.
-- Place the dual clutch as shown in the transmission housing.
-- Tighten the bolts -1 to 12- for the clutch cover diagonally in steps.
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- After installing the transmission fill the ATF and transmission fluid. Refer to the appropriate service information. .
- If the dual clutch is replaced, the dual clutch must be adapted. Refer to Vehicle Diagnostic Tester.
Dual Clutch, Adaptation
-- Connect the Vehicle Diagnostic Tester with the vehicle.
- Network plan or control module list
- 02 - Transmission Electronics, Guided Functions
- 02 - Basic Setting
- Adapt clutch slip points
-- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.
Tightening Specifications
- Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH