Overview - Flywheel And Dual Clutch

Fig 1: Exploded View Of Flywheel and Dual Clutch Seals And Bearings

Courtesy of AUDI OF AMERICA, LLC

Flywheel
- Refer to the Parts Information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH COVER .
- For the input shaft
Dual Clutch
- Refer to the Parts Information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Engaging Bearing
- Pay attention to the installation position
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Slave Cylinder
- Can only be replaced together with the dual clutch
- Removing and Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Bolt
- Tightening specification 12 Nm + 90°
- Tighten diagonally to the tightening specification
- Replace after removing
Seal
- Replace after removing
Double Shaft Seal
- Replace after removing
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
Guide Sleeve
- Pay attention to the installation position
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .
Seal
- Replace after removing
Seal
- Replace after removing
Seal
- Replace after removing
Alignment Sleeve
Bolt
- Tightening specification 5 Nm + 30°
- Tighten evenly
- Not present depending on the version
Bolt
- Tightening specification 60 Nm
- M10 X 15.5