ATF, Draining And Filling

Special tools and workshop equipment required

Oil Filler:VAS6262A

Fig 1: Identifying Oil Filler Adapter
Courtesy of AUDI OF AMERICA, LLC
Oil Filler - Jointed Hose:VAS6262/5
If necessary, Oil Filler - Adapter 6:VAS6262/6

Fig 2: Adapter For Oil Filling 6 VAS 6262/6
Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit:SMN372500

Fig 3: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Original 1 liter container
Protective Eyewear
Acid-Resistant Safety Gloves

Draining

NOTE:

To drain the ATF, the transmission should be at its operating temperature. Do not start the engine when there is either very little or no ATF in the transmission.

Follow all applicable disposal regulations.

The engine is off.
Move the vehicle onto a 4-column workshop hoist or over a work pit so it is completely level.
Transmission is in "P".
The parking brake button is pressed to activate the electro-mechanical parking brake.

-- Remove the center or rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the transmission.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Open the ATF drain plug -arrow A- and drain the ATF.

CAUTION:

Risk of damaging the transmission.

Do not start the engine when there is no ATF in the transmission.

-- Tighten the drain plug -arrow A- all the way.

ATF, Filling

CAUTION:

Risk of damaging the transmission.

Only use the ATF available as a replacement part for the automatic transmission 0D6.
Using other fluids can cause malfunctions or transmission failure.
Refer to the appropriate Electronic Parts Information for the allocation.
The ATF filler adapter must be clean. Do not mix the ATF with any other ATF types.

-- Use the Oil Filler:VAS6262A to secure the fluid container as high up on the vehicle as possible. Refer to the appropriate Electronic Parts Information for the ATF specification.

-- Remove the plug for the ATF check and fill hole -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Oil Filler - Jointed Hose:VAS6262/5 into the ATF check and fill hole -arrow-.

Fig 4: Identifying VAS 6262/5 Into ATF Check And Fill Hole, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Fill the ATF using the adapter until the ATF starts to leak out of the check and fill hole.

-- Start the engine in "P" position.

-- Continue filling in the ATF using the adapter until the ATF starts to leak out of the check and fill hole.

-- Tighten the old plug for the ATF check and fill hole hand-tight.

-- Check the ATF level and correct if necessary. Refer to ATF LEVEL, CHECKING .

NOTE:

Observe all notes and test requirements for "Checking ATF level and correcting".

Tightening Specifications

Refer to OVERVIEW - ATF CIRCUIT, DRAIN AND PLUG