Overview - SUBFRAME
- Bolt
- Tightening specification. Refer to the appropriate Service Information .
- Rear Final Drive
- Additional Bearing
- For the rear final drive
- Removing and installing. Refer to the appropriate Service Information .
- Bolt
- 130 Nm + 180°
- Always replace after removing
- Diagonal Brace
- Overview. Refer to OVERVIEW - UNDERBODY CROSSMEMBERS .
- Front Hydraulic Bonded Rubber Bushing
- For the subframe
- Removing and Installing. Refer to SUBFRAME FRONT HYDRAULIC BONDED RUBBER BUSHING, REPLACING .
- Installation position. Refer to Fig 3.
- Subframe
- Removing and Installing. Refer to SUBFRAME, REMOVING AND INSTALLING .
- Rear Bonded Rubber Bushing
- For the rear final drive
- Removing and Installing. Refer to REAR BONDED RUBBER BUSHING FOR REAR FINAL DRIVE, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 4.
- Bolt
- Tightening specification. Refer to the appropriate Service Information .
- Rear Bonded Rubber Bushing
- For the subframe
- Removing and Installing. Refer to SUBFRAME REAR BONDED RUBBER BUSHING, REPLACING .
- Bolt
- 130 Nm + 180°
- Always replace after removing
- Balance Weight
- Installation position. Refer to Fig 2.
- Bolt
- 50 Nm +180°
- Always replace after removing
- Nut
- Tightening specification. Refer to the appropriate Service Information .
Vibration Damper Installation Position
- The beveled surface -arrow- must point upward.
Subframe Hydraulic Front Bonded Rubber Bushing Installation Position
- The groves -arrows- are perpendicular to the direction of travel.
Rear Bonded Rubber Bushings Installation Position for the Rear Final Drive.
- The grooves -arrows- on the bonded rubber bushings -1- are at a right angle.
Steering Adapter/Subframe Threaded Connection
Only on vehicles without rear axle steering.
CAUTION:
There Is a Risk of Accident Due to a Loosened Steering Adapter/Subframe Threaded Connection.
- Do not loosen the steering adapter/ subframe threaded connection.
- Replace the bolts after removing them.
-- Bring the steering adapter -1- into the installation position and install the bolts by hand all the way.
-- Align the steering adapter with the : T40393 to the subframe and tighten the bolts -Item 7- OVERVIEW - REAR AXLE STEERING - List Item: Bolt .