Condensers, Removing And Installing, S4/S5 TDI Gen III And RS Models: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- For all following procedures immediately seal all the open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .
- Pay attention to the notes for the condenser. Refer to RADIATOR AND CONDENSER ASSEMBLY .
-- Remove the bumper cover bracket together with the impact member. Refer to OVERVIEW - LOCK CARRIER and IMPACT GUARD, REMOVING AND INSTALLING .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING FROM CONDENSER .
S4/S5 TDI Gen III
-- Release the catches -arrow- and remove the air duct -1 and 3-.
RS Models
-- Release the catches in direction of -arrow- and remove the air duct -1 and 3-.
Continuation for All Vehicles
-- Disconnect the connector -1- for the High Pressure Sensor -G65-.
-- Remove the bolt -2-.
-- Release the left and right catches in direction of -arrows-, disengage and remove the condenser on the radiator.