OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "2"
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Perform the preparatory work. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .
- Circlip with Rubber Disc
- Removing and Installing. Refer to BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2" .
- The rubber disc that is vulcanized on serves as noise insulation during low compressor output when engine is idling
- Drive Plate
- Tightening specification: 35 Nm
- Attached to the A/C compressor input shaft
- There are different versions. Refer to the appropriate Parts Information.
- The overload protection activates when the torque is too high (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.
- Removing and Installing. Refer to BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2" .
- Circlip
- Always replace
- Install on correct side (flat side toward A/C compressor)
- Removing and Installing. Refer to BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2" .
- Spacer
- Dimensions: 17.5 x 10 x 3 mm
- Rubber Elements
- Quantity: 6, install on proper side. Refer to BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2" .
- For installation, coat rubber elements, for example with tire mounting paste or a soap solution (as a lubricant)
- Belt Pulley
- There are different versions. Refer to the appropriate Parts Information.
- Removing and Installing. Refer to BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2" .
- A/C Compressor
- Without A/C Clutch -N25-
- There are different versions installed depending on the engine and the vehicle market. Refer to the appropriate Parts Information.
- Clean the A/C compressor flange before installing the belt pulley.