Engine, Supporting In Installation Position

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Support Bridge:10-222A
Engine Support Bridge - Spindle:10-222A/11
Engine Support - Supplement Kit:T40093A

Procedure

-- Remove the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the left and right covers for the fender. Refer to OVERVIEW - FENDER .

-- Position the :10-222A at the left and right on the longitudinal member.

Courtesy of AUDI

-- Engage the :10-222A/11 at the left and right on the engine lifting eyes.

-- Tension the engine with the spindles slightly until the engine mount is not under a load.

Assembling

Assemble in the reverse order of removal. Note the following:

-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .