Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position and pretension it with the Engine Support Bridge - Spindle:10-222A/11 until the pressure on the engine mount is released. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the front wheel spoiler and drive axle cover. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Disconnect the corresponding connector -arrow- for the electrohydraulic engine mount solenoid valves.

Fig 1: Left/Right Electrohydraulic Engine Mount Solenoid Valve -N144- / -N145- Component Location

Courtesy of AUDI

Left Engine Mount:

-- Remove the left front lower longitudinal member. Refer to Lock Carrier ; Lower Longitudinal Member, Removing and Installing.

-- Remove the ribbed belt from the A/C compressor belt pulley. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the A/C compressor from the bracket and tie it up on the left side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .

Right Engine Mount:

Courtesy of AUDI

-- Remove the ribbed belt from the generator belt pulley. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the nut -arrow- and free up the ground wire.

Continuation for Both Sides:

Courtesy of AUDI

-- Remove the bolts -arrows- and engine mount -1-. (Shown left).