Rear Seat Belt Latch, Removing And Installing, Single Seats

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Right Seat Belt Latch, Removing

-- Remove the right seat cushion. Refer to SEAT CUSHION, REMOVING AND INSTALLING, SINGLE SEATS .

-- If equipped, disconnect and free up the seat belt switch connector -1-.

Courtesy of AUDI

-- Remove the bolt -2- and remove the seat belt latch -3-.

Left Seat Belt Latch, Removing

-- Remove the left seat cushion. Refer to SEAT CUSHION, REMOVING AND INSTALLING, SINGLE SEATS .

-- If equipped, free up the seat belt switch wire -1- and disconnect the connector.

Courtesy of AUDI

-- If equipped, disconnect and free up the seat belt switch connector -4-.

-- Remove the bolt -3- and then remove with the seat belt latch -2-.

Center Seat Belt Latch, Removing

-- Remove the left single seat. Refer to SINGLE SEATS, REMOVING AND INSTALLING .

-- Unclip the seat belt latch cover. Refer to INNER BACKREST HINGE TRIM PANEL, REMOVING AND INSTALLING, SINGLE SEATS .

-- If equipped, free up the seat belt switch wire -1- and disconnect the connector.

Courtesy of AUDI

-- Remove the bolt -2- and remove the seat belt latch -3-.

Installing

Install in the reverse order of removal while noting the following:

Tightening Specifications

Refer to OVERVIEW - REAR SEAT BELT LATCH .