Rear Axle Toe, Adjusting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
Procedure
-- Remove the nut -1- from the threaded connection for the tie rod/subframe, and install the new nut all the way.
-- Adjust the toe by turning the eccentric bolt -2-.
NOTE:
To turn the eccentric bolt, turn the hex head at the >>top of the bolt<<.
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
NOTE:
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.
-- Tighten the nut and check the toe value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK