Rear Axle Camber, Adjusting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
Procedure
-- Remove the nut -1- from the subframe/rear lower transverse link threaded connection and install the new nut all the way.
-- Adjust the camber by rotating the adjusting bolt -2-.
NOTE:
To turn the adjusting screw, turn the hex head at the >>top of the screw<<.
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
NOTE:
The maximum adjustment range is 135° to left or right of center position.
Do not rotate the adjusting bolt -2- further once the end position has been reached or the components will be damaged.
For clarity the rear wheel is not shown.
-- Tighten the nut and check the camber value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK