Overview - Sliding Sunroof
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Glass Panel
- Front
- Removing and Installing. Refer to GLASS PANEL, REMOVING AND INSTALLING, FRONT .
- Adjusting. Refer to GLASS PANEL, ADJUSTING .
- Perform the adaptation after installing. Refer to Sunroof Motor -V1-, PROGRAMMING .
- Emergency Opening. Refer to OPERATING WITHOUT ELECTRICITY .
- Seal
- For the front glass panel
- Removing and Installing. Refer to GLASS PANEL SEAL, REMOVING AND INSTALLING, FRONT .
- Seal
- For roof opening
- Replace after removing
- Removing and Installing. Refer to ROOF OPENING SEAL, REMOVING AND INSTALLING .
- Seal
- For the glass panel
- Removing and Installing. Refer to GLASS PANEL SEAL, REMOVING AND INSTALLING, REAR .
- Reinforcement Plate
- Glass Panel
- Rear
- Removing and Installing. Refer to GLASS PANEL, REMOVING AND INSTALLING, REAR .
- Adjusting. Refer to GLASS PANEL, ADJUSTING .
- Perform the adaptation after installing. Refer to Sunroof Motor -V1-, PROGRAMMING .
- Bolt
- Replace after removing
- Self-locking
- 5.5 Nm
- Bolt
- Replace after removing
- Self-locking
- 5.5 Nm
- Seal
- Inner
- Attached from the inside onto the sunroof frame
- Foam Seal
- Bonded to the sunroof frame
- Replace after removing
- Sunroof Frame
- Removing and Installing. Refer to SUNROOF FRAME, REMOVING AND INSTALLING .
- Perform the adaptation after installing. Refer to Sunroof Motor -V1-, PROGRAMMING .
- Sunroof Shade Motor -V260-
- Removing and Installing. Refer to Sunroof Shade Motor -V260-, REMOVING AND INSTALLING .
- Perform the adaptation after installing. Refer to Sunroof Shade Motor -V260-, ADAPTING .
- Bolt
- Quantity: 2
- 3 Nm
- Nut
- Tightening sequence
- 8 Nm
- Bolt
- Quantity: 2
- 3 Nm
- Sunroof Motor -V1-
- Removing and Installing. Refer to Sunroof Motor -V1-, REMOVING AND INSTALLING .
- Perform the adaptation after installing. Refer to Sunroof Motor -V1-, PROGRAMMING .
- Sunroof Control Module -J245-
- Removing and Installing. Refer to Sunroof Control Module -J245-, REMOVING AND INSTALLING .
- Perform the adaptation after installing. Refer to Sunroof Control Module -J245-, PROGRAMMING .
- Bolt
- Replace after removing
- Self-locking
- 5.5 Nm