CLUTCH PLATE, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" (WITH A/C Clutch -N25-): Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Perform the preparatory work. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

-- Remove the cap -A-.

Fig 1: Identifying A/C Compressor Input Shaft Components

Courtesy of AUDI OF AMERICA, LLC

-- Hold the compressor shaft -B- securely with a commercially available hex socket wrench (7 mm) and turn the clutch plate -C- in the direction of the -arrow-.

TIP

The torque to drive the A/C compressor is transferred to the clutch plate -C- via the threaded connection. If, when operating the A/C compressor, the clutch plate -C- was attached to the A/C compressor shaft -B- so tightly that it can no longer be loosened (the 7 mm hex fitting cannot transfer the necessary torque), the A/C compressor must be replaced.