BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "1": Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Perform the preparatory work. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .
-- Remove the cap -A-.
-- Hold the compressor shaft -B- with a commercially available hex socket (7 mm) and turn the drive plate -C- together with the belt pulley -E- in the direction of the -arrow-.
TIP
- The torque to drive the A/C compressor is transferred to the drive plate -C- via the threaded connection.
- If, when operating the A/C compressor, the drive plate -C- was attached to the A/C compressor shaft so tightly that it can no longer be loosened (the 7 mm hex fitting -B- cannot transfer the necessary torque), the A/C compressor must be replaced.
-- Remove drive plate -C-.
-- Remove the circlip -A-.
-- Remove the belt pulley -B-.