Installed Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The vehicle in the illustration is only a basic outline.

Fig 1: Identifying Overview Of Assembled Calibration Equipment

Courtesy of AUDI OF AMERICA, LLC

Calibration Tool - Wheel Center Mountings:VAS6350/1
- With wheel bolt adapter and measuring paddle
Calibration Tool - Wheel Center Mountings:VAS6350/1
- With wheel bolt adapter and measuring paddle
Right Catch Bracket
- To mount the Spacing Laser:VAS6350/2 for the distance measurement
Plastic Foot
- Adjustable for adjusting the horizontal position of the Calibration Tool :VAS6350A
- Quantity: 3
Calibration Tool - Linear Laser:VAS6350/3
- With "laser protective eyewear"
- On the Calibration Tool:VAS6350A
- Refer to Calibration Tool - Line LaserVAS6350/3A Owner's Manual for handling.
Calibration Tool - Spacing Laser:VAS6350/2
- For distance measurement
- Refer to the Calibration Tool - Spacing LaserVAS6350/2A Operating Instructions for handling.
Level
- On the Calibration Tool :VAS6350A
- For checking the horizontal position
Left Catch Bracket
- To mount the Spacing Laser:VAS6350/2 for the distance measurement
Calibration Tool :VAS6350
- Between the catch bracket on the calibration board and the Calibration Tool - Wheel Center Mounting:VAS6350/1A - dimension -a- : 1.47 m to 1.90 m (4.8 feet to 6.2 feet)

Calibration Board Orientation

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m (4.8 feet to 6.2 feet) to the rear wheels, see -dimension A- in the overview illustration. Refer to Installed Overview .

-- Bring the Calibration Unit:VAS6350A into a horizontal position.

-- Twist the plastic feet under the calibration board so that the air bubble in the level is located exactly in the center of the indicator -arrow-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The vehicle in the illustration is only a basic outline.

Fig 2: Identifying Laser -1- On Calibration Platform Set To Align Entire Calibration Platform With Vehicle

Courtesy of AUDI OF AMERICA, LLC

-- Wear "laser protective eyewear".

-- Turn on the Calibration Tool - Linear Laser:VAS6350/3A -1- on the Calibration Tool: VAS6350A .

-- Align the Calibration Tool :VAS6350A so that the Calibration Tool - Linear Laser:VAS6350/3A -1- strikes the center of the emblem on the rear lid.

-- Check that the Audi rings are centered on the rear. Correct the laser beam accordingly.

Continue calibrating the Rearview Camera -R189-. Refer to Rearview Camera -R189-, CALIBRATING .