Vehicle Transport Mode, Deactivating

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off.

NOTE:

The Full pre-delivery inspection test program may also be performed as part of the pre-delivery inspection.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .

-- Switch to the "Special Functions" tab and select the following program:

34 - Activate/deactivate vehicle transport mode

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

The vehicle can lower by deactivating the vehicle transport mode.