Transmission Fluid Auxiliary Hydraulic Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- The connector terminals -2 and 3- for the wire -1- must be inserted correctly in the transmission housing.
- The connector terminals must not be interchanged.
-- Carefully and without any aids, replace the O-ring -D- on the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-.
- The Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- must be replaced if the O-ring seat is damaged or scratched.
-- Insert the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- with a new O-ring -D-.
-- Tighten the bolts in the following sequence -1 to 3-.
- -1, 2 and 3- : M6x28
-- Insert and engage the connector -B- to the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A-.
-- Route the wire -C- according to the illustration and secure it -arrows-.
-- Install the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Fill the ATF. Refer to ATF, DRAINING AND FILLING .