Exhaust Temperature Regulation Components, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Exhaust Gas Temperature Sensor 3 -G495- cylinder bank 1 (right)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -2- from the bracket and disconnect it.

-- Remove the Exhaust Gas Temperature Sensor 3 - G495- -item 1- with a suitable tool from the Diesel Engine Tool Set:T10395B .

Free up the wire from the Exhaust Gas Temperature Sensor 3 -G495-.

-- Guide the Exhaust Gas Temperature Sensor 3 -G495- under the engine bracket for the driving dynamic support OVERVIEW - DRIVING DYNAMIC SUPPORT List Item:Engine Bracket Lower Section .

CAUTION:

There is a risk of burn injuries due to a hot exhaust system.

Possible to burn hands and other parts of the body.

- Allow the exhaust system to cool.

Exhaust Gas Temperature Sensor 3 Bank 2 - G497- cylinder bank 2 (left)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -1- from the bracket, disconnect it, and free up the wire.

CAUTION:

There is a risk of burn injuries due to a hot exhaust system.

Possible to burn hands and other parts of the body.

- Allow the exhaust system to cool.

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -item 2- with a suitable tool from the Diesel Engine Tool Set:T10395B .