Overview - Driving Dynamic Support
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 55 Nm
- Driving Dynamic Support
- Removing and installing. Refer to DRIVING DYNAMIC SUPPORT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- 55 Nm
- Washer
- Installed, depending on the version
- Mounting Bracket
- For driving dynamic support
- Removing and installing. Refer to DRIVING DYNAMIC SUPPORT MOUNTING PLATE, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- 20 Nm
- Nut
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Engine Bracket Upper Section
- For driving dynamic support
- Removing and installing. Refer to DRIVING DYNAMIC SUPPORT ENGINE BRACKET, REMOVING AND INSTALLING .
- Engine Bracket Lower Section
- For driving dynamic support
- Removing and installing. Refer to DRIVING DYNAMIC SUPPORT ENGINE BRACKET, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
Driving Dynamic Support Engine Bracket - Tightening Specifications and Sequence
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1, 5 and 3- | Install all the way by hand |
| 2. | -1 and 5- | 20 Nm |
| 3. | -3- | 55 Nm |