Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING, AUDI Q7/Q8, VEHICLE INTERIOR AT RIGHT A-PILLAR: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Sway Stabilization Control Module -J924- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the glove compartment. Refer to OVERVIEW - GLOVE COMPARTMENT .
-- Remove the A-pillar lower right trim panel. Refer to OVERVIEW - A-PILLAR TRIM PANEL .
-- De-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Disconnect the connector from the Sway Stabilization Control Module -J924-.
-- Press the two retaining tabs on the bracket back using a screwdriver. Remove the Sway Stabilization Control Module -J924- downward from the bracket.