Component Location Overview - 48V System Wire Junction
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Mount
- For Suppressor -C24-
- Removing and Installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Suppressor -C24-
- Removing and Installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING, 48V SYSTEM .
- Cap
- Positive Cable
- To starter, generator
- Nut
- 16 Nm
- Positive Cable
- From the 12V battery
- Nut
- 20 Nm
- Terminal 30 Wire Junction 2 -TV22-
- Component Location Overview. Refer to Component Location Overview - and .
- Nut
- Tightening specification -item 17- Component Location Overview - and.
- Wire
- To the Suspension Stabilization Control Module 1 -J1152-
- Nut
- 20 Nm
- Wire
- To the Electric Compressor Control Module -J1123-
- Nut
- 9 Nm
- Terminal 40 Wire Junction -TV66-
- Removing and Installing. Refer to Terminal 40 Wire Junction -TV66-, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- Quantity: 2
- Nut
- 3 Nm
- Quantity: 3
- Terminal 30 Wire Junction -TV2-
- Removing and Installing. Refer to Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING, VEHICLES WITH 48V SYSTEM .