Engine, Securing To Engine And Transmission Holder

Special tools and workshop equipment required 

• Engine and Gearbox Bracket:VAS6095A 
  Fig 1: Identifying Engine and Gearbox Bracket VAS6095A

  Courtesy of AUDI
• Engine/Transmission Holder - Universal Mounting:VAS6095/1  and V6 TFSI Engine Bracket:VAS6095/1-15 
  Fig 2: Identifying Universal Mount VAS 6095/1

  Courtesy of AUDI

• Engine lifted with the workshop crane. Refer to ENGINE, REMOVING FROM SCISSOR LIFT TABLE .

Procedure

Courtesy of AUDI

-- Remove the bolts -arrows- and the left engine support -1-.

If the Chain Drive on the Connection Should be Worked On:

Courtesy of AUDI

-- Remove the vacuum hose -2- at the same time to not damage it.

-- Free up the wiring harness -3-.

-- Remove the nuts -4- and bolt -5-.

-- Remove the vacuum reservoir -1-.

-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.

Courtesy of AUDI

Continuation:

Courtesy of AUDI

-- Remove the ground wire nut -arrow-.

-- Remove the bolts -arrows- and remove the right engine support -1-.

Courtesy of AUDI

Vehicle without High-Voltage System:

-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .

Continuation for All Vehicles:

Courtesy of AUDI

-- Secure the engine to the Engine And Transmission Holder:VAS6095A  using the Engine/Transmission Holder - Universal Mounting:VAS6095/1  and Bracket For 3.0L TFSI:VAS6095/1-15  and tighten to 40 Nm.