Engine, Removing From Scissor Lift Table

WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Lifting Tackle:3033

Fig 1: Lifting Tackle (3033)
Courtesy of AUDI
Shop Crane:VAS6100

Fig 2: Identifying Shop Crane
Courtesy of AUDI
Lift Arm Extension:VAS6101

Fig 3: Identifying Lift Arm Ext./Workshop Hoist VAS 6101
Courtesy of AUDI

Procedure

NOTE:

The engine may only be transported in the manner described and without the transmission.

Engine/transmission assembly removed and separated on Scissor Lift Table:VAS6131B . Refer to ENGINE AND TRANSMISSION, SEPARATING .
Vehicles without high-voltage system: engine secured with the Scissor Lift Table - Q7 Set - Articulated Joint Support:VAS6131/13-7 .
Vehicles with high-voltage system: engine secured with the Engine Support:T10533/1 .

-- Attach the Lift Arm Extension:VAS6101 to the Shop Crane:VAS6100 .

Courtesy of AUDI

-- Engage the Lifting Tackle:3033 at the engine lifting eyes and at the workshop crane and pretension.

Vehicle without High-Voltage System:

Courtesy of AUDI

-- Remove the Articulated Joint Support:VAS6131/13-7 from the engine.

Vehicle with High-Voltage System:

Courtesy of AUDI

-- Remove the Engine Support:T10533/1 from the engine.

Continuation for All Vehicles:

Courtesy of AUDI

-- Remove the left and right bolts -2-. (Shown on the installed engine.)

-- Pry up the engine with the workshop crane.