Engine, Removing From Scissor Lift Table

WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Lifting Tackle:3033

Fig 1: Lifting Tackle (3033)
Courtesy of AUDI OF AMERICA, LLC
Shop Crane:VAS 6100

Fig 2: Identifying Shop Crane
Courtesy of AUDI OF AMERICA, LLC
Lift Arm Extension:VAS 6101

Fig 3: Identifying Lift Arm Ext./Workshop Hoist VAS 6101
Courtesy of AUDI OF AMERICA, LLC

Procedure

Engine/transmission assembly removed and separated on Scissor Lift Table:VAS 6131B . Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Remove the bolt -arrow- and free up the bracket -3- with the wires -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of injury due to the engine weight shifting.

The possibility for parts of the body to be pinched or crushed increases.

- Transport the engine only without the transmission using the method described.

-- Attach the Lift Arm Extension:VAS 6101 to the Shop Crane:VAS 6100 .

-- Engage the Lifting Tackle:3033 on the engine lifting eyes and on the shop crane as shown.

-- Remove the Scissor Lift Table - Q7 Set - Articulated Joint Support :VAS 6131/13-7 -item 1- from the engine.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolt -2- from the engine mount.

Courtesy of AUDI OF AMERICA, LLC

-- Pry up the engine with the workshop crane.