Upper Air Duct Pipe, Removing And Installing: Removing
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the front noise insulation. Refer to NOISE INSULATION .
-- Remove the left front lower longitudinal member. Refer to LOWER LONGITUDINAL MEMBER, REMOVING AND INSTALLING .
-- Remove the A/C compressor from the bracket and tie it up on the left side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING / A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .
-- Loosen the hose clamp -1- and remove the air duct pipe and tie up to the left side.
-- Remove the reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .
-- Remove the throttle valve control module. Refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .
-- Release the catches -arrows- and remove the air duct -2-.
-- Release the left and right catches in direction of -arrows- and remove the retaining pin -1- for the radiator upward.
-- Push the radiator on the top forward.
-- Press the release buttons -arrow- on both sides and disconnect the EVAP system hose.
-- Free up the wiring harness.
-- Remove the bolts -arrows-.
-- Remove the crankcase ventilation hose -1- by pressing the release buttons on both sides.
-- Release and disconnect the connectors -4 and 5-.
-- Free up the wiring harness -2-.
-- Remove the bolts -arrows-.
-- Remove the vacuum hose -6- and hose -3- for the crankcase ventilation to do so press the release buttons on both sides.
-- Remove the air duct pipe -1-.