Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING: Removing

-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the front left wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the lower left longitudinal member. Refer to OVERVIEW - LOCK CARRIER .

-- Loosen the hose clamps -arrows- on the left and right sides and remove air duct hose -1- (example image).

Courtesy of AUDI

-- Disconnect the connector -1-.

Courtesy of AUDI

-- Remove the bolt -2- and the Charge Air Pressure Sensor 2 -G447- (example image).