Brake Pedal, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi Q7, 2021 Audi Q7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Clean bolts before reusing.
- Replace damaged bolts.
- Always replace self-locking bolts.
- A damaged or bent mounting pin clamp must be replaced.
- A damaged mounting pin must be replaced.
NOTE:
Do not grease the mounting pins.
-- Insert the mounting pin -3- from the left to the right.
-- Secure the mounting pin with the clamp -2- and screw -arrow-.
NOTE:
Make sure the clamp -2- is set completely into the mounting pin groove.
A damaged or bent mounting pin clamp must be replaced.
-- Connect the brake pedal -1- to the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .
WARNING:
Risk of accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.