Brake Pedal, Disconnecting From Brake Booster
WARNING: This page is about a different car, the 2022 Audi Q7, 2021 Audi Q7, and 2020 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Brake Servo Release Tool: T40136
Procedure
-- Remove the footwell vent. Refer to AIR DUCT .
-- Press and hold the brake pedal in the direction of the brake booster.
-- Insert the Brake Servo Release Tool: T40136 and pull in the direction of the driver seat while counterholding at the brake pedal -1- so that it does not move backward. While doing so, the retaining tabs -3- will be pushed out of the pushrod ball head mount -2-.
NOTE:
For clarity, the installation position is shown with the pedal assembly removed.
-- Pull the Brake Servo Release Tool: T40136 and the brake pedal together toward the driver seat. This will pull the brake pedal off the push rod ball head.