Adjusting Buffer, Removing And Installing, A4 Sedan, A5 Coupe And A5 Cabriolet: Installing
WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
TIP:
To secure the adjusting buffer, the Pop Rivet Screw :WHT 005 180 must be inserted using the Pop Rivet Pliers :VAG1765C and Pop Rivet Pliers - Supplement Pieces VAG1765C/2. Refer to the appropriate service information. The >>infomedia search<< can be used here to search for the Pop Rivet Screw :WHT 005 180 in the respective information.
-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .
Install in reverse order of removal and note the following:
-- Check the seal -2- between the adjusting buffer and the rear lid for damage.
-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .