Height, Adjusting Using Adjusting Buffer

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Adjustment dimensions. Refer to REAR LID, ADJUSTING .

Procedure

-- Install the adjusting screw -2- with the protective cap -1- all the way into the adjusting buffer -3- before adjusting the rear lid.

Fig 1: Adjusting Screw, Adjusting Buffer And Cap

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adjusting screw -2- just enough until the protective cap -1- rests on the adjusting buffer with light pretension when the rear lid is closed.

-- Check if the lid is without play and in a flush position by pressing or pulling at the side edges of the rear lid.

-- Repeat the adjustment if necessary.