Roller Bearing, Replacing: Removing
WARNING: This page is about a different car, the 2022 Audi S7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Engine secured on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the crankshaft. Refer to OVERVIEW - CRANKSHAFT .
-- Remove the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
-- Install the Fitting Tool: T40395 on the correct side on the roller bearing.
- The bevel -arrow- faces the roller bearing.
-- Align the Adapter : T40395/3 .
- The side without the bevel -arrows- faces down.
-- Remove the front roller bearing -1- and rear roller bearing -2- inward using the Spindle : T40395/1 , Adapter: T40395/2 and Adapter : T40395/3 by turning the Nut: T40395/4 .
-- Remove the Fitting Tool: T40395 and remove the roller bearing.