Vehicle Transport Mode, Deactivating

WARNING: This page is about a different car, the 2021 Audi SQ7 and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to the appropriate Service Information .

NOTE:

The Full pre-delivery inspection test program may also be performed as an alternative.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Set v and press Accept to select "Work with Guided Fault Finding".

The control module identification and checking the DTC memory occurs next. Observe the instructions and test conditions.

-- Switch to the "Control modules" tab and open the "DTC memory list" to view all of the stored DTC memory entries.

-- Change to the "test plan" tab and perform the specified test programs.