Overview - Cylinder Block, Transmission Side: Notes
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Block
- Alignment Sleeves
- Transmission Side Sealing Flange
- Replace after removing
- With gasket
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Before installing, remove oil residue from crankshaft journal with a clean cloth
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Drive Plate
- Removing and Installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Versions with a manual transmission must have a needle bearing inside the drive plate; if necessary install the needle bearing. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
- For the version with a dual-clutch transmission, then do not install a needle bearing inside the crankshaft. Remove the needle bearing if necessary. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
- Bolt
- 60 Nm +90°
- Replace after removing
- Needle Bearing
- For version with manual transmission
- Replacing. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
- Intermediate Plate
- Be careful not to damage or bend when installing
- Removing and Installing. Refer to Fig 3.
Transmission Side Sealing Flange - Tightening Specifications and Sequence
-- Tighten the bolts -1 to 8- in stages in the sequence shown.
| Step | Tightening Specification |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |
Intermediate Plate, Removing and Installing