Needle Bearing In Drive Plate, Replacing
WARNING: This page is about a different car, the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Only available with the manual transmission a needle bearing is installed in the drive plate.
Special tools and workshop equipment required
- Press Piece - 31.5mm:VW418A
- Press Piece - 28x100mm:VW421
- Bearing Installer - Multiple Use:40-103
- Pneumatic hydraulic press, for example :VAS6654 , not illustrated
Procedure
- The transmission is removed. Refer to the appropriate service information .
- :40-103
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Place the under the drive plate to remove and install.
-- Press out the needle bearing using the :VW421 and workshop press.
- The thinner diameter of the:VW421 points towards the drive plate.
-- Carefully press the needle bearing in all the way using the :VW418A and workshop press.
- Installation position: the closed side of the needle bearing faces the engine.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .