Charge Air System, Checking For Leaks
WARNING: This page is about a different car, the 2022 Audi SQ5 and 2021 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Turbo System Tester Kit:VAG1687
- Turbo System Tester Kit - Adapter 11:VAG1687/11 and Turbo System Tester Kit - Adapter:VAG1687/14
Procedure
-- Pay attention to the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Loosen the hose clamps -arrows- and remove the air duct pipe -1-.
-- Connect the :VAG1687/11 with the :VAG1687/14 to the turbocharger.
-- Connect the hose -arrow- from the :VAG1687 to the adapter.
Additional procedures. Refer to CHARGE AIR SYSTEM, CHECKING FOR LEAKS .
Assembling
- Secure all hose connections with hose clamps that match the ones used in series production.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Tightening Specifications
- Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .