Tie Rod, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the boot. Refer to BOOT, REMOVING AND INSTALLING .

-- Position the front wheels as follows:

For the left tie rod, turn the steering to the left until it stops
For the right tie rod, turn the steering to the right until it stops

-- Remove the spring clip with the :VAG1923 -2- by counterholding at the steering gear steering rack with an open end wrench -1-.

Fig 1: Removing Tie Rod

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There is a risk of the steering gear being destroyed by moisture and dirt.

There must be a visible film of grease present on the steering rack near the splines. If the film of grease is missing, replace the steering gear.