Overview - Air Spring
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lower Transverse Link
- Air Spring
- Removing and installing. Refer to SPRING, REMOVING AND INSTALLING, AIR SPRING .
- Installation position. Refer to Fig 2.
- O-Ring
- If sealing ring is leaking nip open and replace.
- Air Line
- If the connecting piece is removed separately (without the attached lines) check if the cutting ring as a loose components is still in the threads and if necessary remove.
- Connecting piece tightening specification. Refer to OVERVIEW - AIR LINES .
- Not Installed
Air Spring Installed Position
-- When filling the air suspension system check the installation position of the air suspension system:
- The positioning pins of the air spring -2- must engage at the top in the holes in the body -3- and below in the holes in the rear transverse link -4- as shown.
- The catches -arrows- must engage audibly in the rear lower transverse link.