Overview - Front Brakes, Brakes 1LC, 1LE And 1LF
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Shield
- Wheel Bearing Housing
- Bracket
- For brake hose and wire
- Hose Bracket
- for brake hose
- Bolt
- Clean before re-using
- Replace if damaged
- Replace self-locking bolts and nuts after removing
- 20 Nm
- Brake Line/Hose
- Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
- Replace if damaged
- Make sure that tabs are properly seated in the grooves on the bracket.
- Brake line to brake caliper tightening specification: 14 Nm
- Bracket
- For the brake line/hose
- Spring
- Replace if damaged
- Brake Line
- Do not change the bending shape.
- Replace a damaged or bent brake line
- Brake line to brake hose tightening specification: 14 Nm
- Bolt
- Clean before re-using
- Replace if damaged
- Replace self-locking bolts and nuts after removing
- 20 Nm
- Bolt
- Clean before re-using
- Replace if damaged
- Replace self-locking bolts and nuts after removing
- 200 Nm
- Brake Pad Wear Indicator Wire
- For the left inner brake pad with the Left Front Brake Pad Wear Sensor -G34-
- Replace when replacing the pads
- Anti-Friction Plate
- Protective Cap
- Bleed Screw
- Before installing, thinly coat with Assembly Paste:G 052 150 A2 .
- 18 Nm
- Spring Bracket
- Refer to SPRING BRACKET, INSTALLING
- Brake Caliper
- Allocation. Refer to the Parts Information.
Refer to BRAKE CALIPER, REMOVING AND INSTALLING
Refer to BRAKE CALIPER, REPLACING
- Allocation. Refer to the Parts Information.
- Anti-Friction Plate
- Brake Pads
- Allocation. Refer to the Parts Information.
- Inner brake pads with a mount for the brake pad wear sensor
- Check the pad thickness. For the wear limit, refer to BRAKE PADS, CHECKING THICKNESS .
- Always replace on both axles.
- Refer to BRAKE PAD INSTALLATION POSITION, STEEL BRAKES 1LC/1LE/1LF
- Refer to BRAKE PADS, REMOVING AND INSTALLING, BRAKES 1LC, 1LE AND 1LF
- Brake Rotor
- Allocation. Refer to the Parts Information.
- Maximum lateral run-out: 0.06 mm
- If the brake rotor is installed, measure using the Dial Indicator - 0-10mm:VAS6079 and Dial Indicator Bracket:6079/1 .
- Clean away any dirt and rust on the brake rotor, and perform the measurement 10 mm from the outer edge of the brake rotor.
- Always replace on both axles.
- Do not use excessive force to separate the brake rotor from the wheel hub. Use rust remover, if necessary, otherwise the brake rotor could be damaged.
- Refer to BRAKE ROTOR, REMOVING AND INSTALLING
- Bolt
- Clean before re-using
- Replace if damaged
- Replace self-locking bolts and nuts after removing
- 8 Nm
- Bolt
- Clean before re-using
- Replace if damaged
- Replace self-locking bolts and nuts after removing
- 10 Nm