Overview - Bumper Cover, Market-Specific Version

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Bumper Cover (Market-Specific Version)

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Quantity: 4
- 5 Nm
Bolt
- Quantity: 2
- 2 Nm
End Panel
- The bumper cover
- Removing and Installing. Refer to BUMPER COVER END PLATE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Impact Guard
- Equipped on some models
- Removing and Installing. Refer to IMPACT GUARD, REMOVING AND INSTALLING .
Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
Connecting Piece
- Removing and Installing. Refer to CONNECTING PIECE FOR BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
Radiator Grille
- Overview. Refer to OVERVIEW - RADIATOR GRILLE .
Air Intake Grille
- Center
- Removing and Installing. Refer to CENTER AIR INTAKE GRILLE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Lock Carrier Cover
- Removing and Installing. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
Bolt
- Quantity: 7
- 2 Nm
Bolt
- Quantity: 2
- 2 Nm
End Panel
- For the bumper cover side panel
- Removing and Installing. Refer to BUMPER COVER SIDE PANEL END PLATE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .
Securing Strip
- For the bumper cover side panel/lower section
- Removing and Installing. Refer to SECURING STRIP FOR BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
Mount
- For the bumper cover side panel
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Bolt
- 2 Nm
Expanding Rivet
Bolt
- Quantity: 2
- 2 Nm
Bumper Cover Side Panel
- Removing and Installing. Refer to BUMPER COVER SIDE PANEL, REMOVING AND INSTALLING .
- Bumper Cover, Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
Cover
Equipment versions with headlamp washer system
- Washer Nozzle Cover, Removing and Installing. Refer to HEADLAMP WASHER SYSTEM WASHER NOZZLE COVER, REMOVING AND INSTALLING
  Equipment versions without headlamp washer system
- Blind cover, removing and installing. Refer to BLIND COVER IN BUMPER COVER, REMOVING AND INSTALLING .
Bolt
- 2 Nm
Clip
- Quantity: 2
Cap
- For the air intake grille
- Equipped on some models
Bolt
- 2 Nm
Air Intake Grille
- Side
- Removing and Installing. Refer to SIDE AIR INTAKE GRILLE, REMOVING AND INSTALLING, BEFORE PRODUCT IMPROVEMENT .