Vehicle Interior Forced Air Extraction, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bumper cover -E-. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Open the cover in the left and/or right luggage compartment side trim panel.
TIP
- For vehicles without a cover in the luggage compartment side trim panel, the side trim panel (left and/or right) is to be removed (so that the tabs -C- from the vent frame -A- can be loosened to remove) if the forced air extraction vent frame -A- is going to be reused after removing. Luggage compartment side trim panel, removing. Refer to OVERVIEW - LUGGAGE COMPARTMENT SIDE TRIM PANEL .
- If the removed vent frame is not going to be reused, loosen the vent frame -A- from the outside from the opening in the body -D- (the vent frame will be destroyed at the same time).
A5 Coupe and Sportback
-- Remove and install the side bumper cover mount. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Continuation for All Vehicles
-- Release the retainers -C- and push the forced air extraction ventilation vent frame -A- outward from the body opening -D-.