Overview - A/C Compressor Power Unit, All Vehicles Excluding 6-Cylinder 2.9L TFSI Engine
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of A/C Compressor Power Unit, All Vehicles Excluding 6-Cylinder 2.9L TFSI Engine
- Alignment Sleeves
- Quantity: 2
- Oil Drain Plug with Seal
- Denso: 30 Nm
- Denso: seal can be reused
- Sanden: 15 Nm
- Sanden: seal can be reused
- Seals, sealing surfaces and threads must not indicate visible damage, contamination or particles.
- A/C Compressor Bracket
- There are different versions. Refer to the Parts Information.
- Removing and Installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- O-Ring
- Replace. Refer to the Parts Information for the version.
- Coat with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
- High Pressure Side Refrigerant Line
- Refrigerant Line, Disconnecting and Connecting. Refer to REFRIGERANT LINES, REMOVING AND INSTALLING AT A/C COMPRESSOR .
- Screw
- Overview. Refer to OVERVIEW - REFRIGERANT LINES .
- Low Pressure Side Refrigerant Line
- Refrigerant Line, Disconnecting and Connecting. Refer to REFRIGERANT LINES, REMOVING AND INSTALLING AT A/C COMPRESSOR .
- Screw
- Overview. Refer to OVERVIEW - REFRIGERANT LINES .
- O-Ring
- Replace. Refer to the Parts Information for the version.
- Coat with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
- Screw
- Quantity: 3
- There are different versions. Refer to the Parts Information.
Steel bolt with threads on head
- 25 Nm
Steel Bolt
- 25 Nm
Aluminum bolt
- Replace after removing.
- 8 Nm +180°
- A/C Compressor Regulator Valve -N280-
- Check using the Vehicle Diagnostic Tester and refer to the appropriate Wiring Diagram.
- Removing and Installing. Refer to Refrigerant Circuit Components, Replacing .
- A/C Compressor
- There are different versions. Refer to the Parts Information.
- Refrigerant Line, Disconnecting and Connecting. Refer to REFRIGERANT LINES, REMOVING AND INSTALLING AT A/C COMPRESSOR .
- Removing and installing from the bracket. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .
- Removing and Installing. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING .
- Electrical connector
- For A/C Compressor Regulator Valve -N280- and A/C Clutch -N25-
- Belt Pulley with Overload Protection
- There are different versions. Refer to the Parts Information.
- Overview. Refer to OVERVIEW - BELT PULLEY .
- With or without the A/C Clutch -N25- depending on the engine and the A/C compressor.
- Ribbed Belt
- Removing and Installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .