BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2": Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Perform the preparatory work. Refer to PRELIMINARY WORK FOR REPLACING BELT PULLEY .

-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Carefully remove the circlip -A- (with a rubber disc vulcanized on) using a small screwdriver or needle nose pliers.

Fig 1: Identifying Drive Plate, Belt Pulley, And Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the compressor shaft -B- with a commercially available hex socket wrench and turn the drive plate -C- with the belt pulley -D- in the direction of the arrow -E-.

-- Remove drive plate -C-.

-- Remove the circlip -A-.

Fig 2: Identifying Circlip And Pulley

Courtesy of AUDI OF AMERICA, LLC

-- Remove the belt pulley -B-.

TIP

If the belt pulley cannot be removed with the A/C compressor installed, remove the A/C compressor. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING .