Cylinder Head, Removing And Installing: Installing

• Replace the bolts that were tightened with an additional turn after removing them.
• Replace the self-locking nuts, gaskets, seals and O-rings after removal.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
• Only unpack the new cylinder head gasket immediately before installing.
• To prevent the cylinder head gasket silicone layer and recessed area from being damaged, always handle the gasket extremely carefully.
• If a replacement cylinder is installed, only remove the plastic base right before cylinder head is installed to protect open valves.
• When installing a replacement cylinder head, the contact surfaces between the roller rocker lever and cam running surface need to be oiled before the cylinder head cover can be installed.
• When replacing the cylinder head or cylinder head gasket, replace all of the coolant and engine oil.

-- Carefully remove the sealant residue from the cylinder head and cylinder block.

-- Make sure that no long grooves or scratches result.

-- Carefully remove all lapping and sanding residue.

-- Clean oil and coolant residue out of the blind holes for the cylinder head bolts in the cylinder block

-- Position the cylinder head gasket.

• Pay attention to centering pins in cylinder block -arrows-.
• Pay attention to the cylinder head gasket installation position: the part number must be readable from the intake side.

-- If the crankshaft was turned in the meantime: bring the piston for cylinder 1 to TDC and then turn the crankshaft back again slightly.

• When turning the crankshaft pay attention that no components are not damaged by the timing chain.

-- Position the cylinder head.

-- Install and tighten the cylinder head bolt.

TIP: 

It is not required to retighten the cylinder head bolts after repairs.

Further installation is performed in reverse order of removal, while noting the following:

-- Turn the crankshaft using the : T40263  , : T40314  and the 24 mm socket in direction of -arrow- until the vibration damper is at "TDC".

Courtesy of AUDI OF AMERICA, LLC

• The notch -1- on the vibration damper must align with the arrow marking -2- on the lower timing chain cover.
• The mark on the lower timing chain cover is located in the >>four-o'clock position<<.

-- Install the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Install the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Follow all steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Install the spark plugs. Refer to OVERVIEW - IGNITION SYSTEM .

-- Change the engine oil. Refer to ENGINE OIL .

-- Change the coolant. Refer to COOLANT, DRAINING AND FILLING .

There are additional procedures depending on the model. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .