Battery, Disconnecting And Connecting, Battery In Luggage Compartment: Connecting

WARNING: This page is about a different variant/trim than selected.

Fig 1: Connecting Battery

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- from the Battery Monitoring Control Module -J367- -3-.

-- Connect the battery ground cable terminal clamp to the battery negative terminal "-" by hand and tighten the nut -1-.

-- Reconnect the connector to the Battery Monitoring Control Module -J367-.

When the battery is connected, the following steps must be performed:

Activate the one-touch up/one-touch down power window regulators. Refer to the Owner's Manual.
Check DTC memories of all control modules and erase "Undervoltage" DTC if necessary using the Vehicle Diagnostic Tester.

NOTE:

After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.

Tightening Specifications