Overview - SUBFRAME Mount
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The illustration show the assembly mounts in a vehicle with a TDI engine.
- 1 -
Bolt
- Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 2 -
Engine Support
- Removing and installing. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 3 -
Engine Mount
- With support arm
- Removing and installing. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 4-7 -
Bolt
- Tightening specification. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 8 -
Pendulum Support
- Removing and installing. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 9-13 -
Bolt
- Tightening specification. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 14 -
Transmission Mount
- With support arm
- Removing and installing. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 15 -
Bolt
- Tightening specification. Refer to tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT 2.0L or OVERVIEW - ASSEMBLY MOUNTS 2.0L DIESEL .
- 16 -
Bolt
- 40 Nm +90° turn
- Always replace after removing
- 17 - Transmission Support
- 18 -
Bolt
- 40 Nm +90° turn
- Always replace after removing