Bevel Box, Tightening Specification
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | Install the bolts all the way in by hand |
| 2. | -Arrows- | 40 Nm |
| 3. | -Arrows- | Tighten 90° further |
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
Additional Tightening Specifications
- Bevel box assembly overview. Refer to OVERVIEW - BEVEL BOX .
- Differential assembly overview. Refer to OVERVIEW - DIFFERENTIAL .
- Subframe mount; subframe mount assembly overview. Refer to the appropriate service information. .
- EGR; assembly overview - EGR. Refer to OVERVIEW - EXHAUST GAS RECIRCULATION .
- Driveshaft; assembly overview - driveshaft. Refer to DRIVE AXLE .
- Lower control arm, control arm assembly overview; lower control arm, control arm. Refer to - OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .
- Noise insulation; assembly overview - noise insulation. Refer to OVERVIEW - NOISE INSULATION .