Bevel Box, Tightening Specification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -Arrows- | Install the bolts all the way in by hand |
| 2. | -Arrows- | 40 Nm |
| 3. | -Arrows- | Tighten 90° further |
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1- | Install the bolts all the way in by hand |
| 2. | -2- | 40 Nm |
| 3. | -1- | 40 Nm |
Additional Tightening Specifications
- Bevel box assembly overview. Refer to OVERVIEW - BEVEL BOX .
- Differential assembly overview. Refer to OVERVIEW - DIFFERENTIAL .
- Subframe mount; subframe mount assembly overview. Refer to ASSEMBLY MOUNTS [For engine(s) CRUA, DEJA] .
- EGR; assembly overview - EGR. Refer to EXHAUST PIPES/MUFFLERS [For engine(s) CNSB, CNTC] .
- Driveshaft; assembly overview - driveshaft. Refer to DRIVE AXLE .
- Lower control arm, control arm assembly overview; lower control arm, control arm. Refer to LOWER CONTROL ARM AND BALL JOINT .
- Noise insulation; assembly overview - noise insulation. Refer to NOISE INSULATION .